TM 5-3895-369-14
Table 7-1. Equipment Data - CONT.
Engine Specifications - Continued
Cylinder Head - cont.
Valve Springs
Free Length ................................................................... 2.190 in. (55.63 mm)
Inclination - maximum ................................................ 0.039 in. (1.0 mm)
Spring Tension - minimum ......................................... 65.0 to 72.2 lb (289.32 N) compress to a height of
1.94 in. (49.25 mm)
Rocker Lever Bore ......................................................... 0.7480 to 0.7500 in. (19.000 to 19.051 mm)
Rocker Shaft Diameter ................................................. 0.7456 to 0.7470 in. (18.938 to 18.975 mm)
Camshaft
Diameter at Peak of Lobe
Intake - minimum ......................................................... 1.852 in. (47.040 mm)
Exhaust - minimum ...................................................... 1.841 in. (46.770 mm)
Lift Pump - minimum .................................................. 1.398 in. (35.5 mm)
Journal - minimum ........................................................ 2.1245 in. (53.962 mm)
End Play ........................................................................... 0.007 to 0.011 in. (0.17 to 0.29 mm)
Tappet Stem Diameter ........................................................ 0.627 to 0.629 in. (15.936 to 15.977 mm)
Lube Pump
Gerotor Tip Clearance - maximum ............................. 0.007 in. (0.1778 mm)
Port Plate Clearance - maximum ................................. 0.005 in. (0.127 mm)
Body Bore Clearance . maximum ................................ 0.015 in. (0.381 mm)
Turbocharger
Shaft Bearing Diameter - minimum ............................ 0.432 in. (10.97 mm)
Shaft End Play ................................................................ 0.001 to 0.003 in. (0.03 to 0.08 mm)
Radial Clearance ............................................................ 0.012 to 0.018 in. (0.30 to 0.46 mm)
Injection Pump Gear Backlash .......................................... 0.003 to 0.013 in. (0.08 to 0.33 mm)
Camshaft Gear Backlash ..................................................... 0.003 to 0.013 in. (0.08 to 0.33 mm)
Lube Pump Gear Backlash ................................................. 0.003 to 0.013 in. (0.08 to 0.33 mm)
Cooling System
Capacity ................................................................................. 6 gallons (23 I)
Fuel System:
Fuel Tank Capacity .............................................................. 55 gal. (208.2 1)
Fuel Injector Pump ............................................................. Mechanical, external
Governor ............................................................................... Mechanical, internal
Fuel Injectors ........................................................................ Mechanical, pressure activated
Hydraulic System
Hydraulic Tank Capacity .................................................... 42 gal. (159.9 1)
Hydrostatic Pump Capability ............................................. 17.5 gpm (66.23 Ipm)
Hydrostatic Motor Capability ............................................ 10.0 gpm (37.85 lpm)
Electrical
Batteries ................................................................................. Two - 12.volt
Starter .................................................................................... 24 volt (solenoid attached).
Alternator .............................................................................. 24 volt/45 amp.
Lighting ................................................................................. 24 volt
Additive Instrumentation/Horn ......................................... 12 volt
Additive System
Pump Capability ................................................................... 210 gpm at 605 rpm (maximum)
Motor ..................................................................................... Hydraulic, variable speed
Spray Bar ............................................................................... External, rotor hood mounted, 21 valve
1-8
