TM 5-3895-359-14&P
SPECIFICATIONS
Specifications, clearances and wear limits are listed
used engine parts and still ensure satisfactory
performance. It should be emphasized that the figures
below.
It should be specifically noted that the
given as "Limits" must be qualified by the judgement of
clearances apply only when all new parts are used at the
personnel responsible for installing new parts. These
point where the various specifications apply. This also
wear limits are, in general, listed only for the parts more
applies to references within the text of the manual. The
frequently replaced in engine overhaul work.
For
column entitled "Limits" in this chart lists the amount of
additional information, refer to the text.
wear or increase in clearance which can be tolerated in
TABLE OF SPECIFICATIONS, NEW CLEARANCES AND WEAR LIMITS
These limits also apply to oversize and undersize parts.
ENGINE PARTS (Standard Size, New)
MINIMUM
MAXIMUM
LIMITS
Blower
Backlash (timing gears) ...........................................................
.0005 "
.0025 "
.0040 "
Oil seal or seal collar (below end plate surface)........................
.0020 "
.0080 "
Dowel pin (projection beyond inside face
of end plates) .................................................................
.3800 "
10-4-23
