TM 5-3895-359-14&P
SPECIAL PLUG TORQUE SPECIFICATIONS
APPLICATION
*PLUG
ASSEMBLY
Oil gallery plug ..................................... 3/8 " Dryseal PTF thread
Assemble with max.
0.0625" protrusion
from
surface
Cylinder head (side) ....................................................... 3/8-16 "
Assemble flush to 0.0625 " protrusion from
surface
Cylinder head (top)........................................ 1/2 "PTF-SAE short
Flush to 1.1250" recessed
Cylinder head (end)............................ 3/4 " Dryseal PTF-SAE short
Flush to 0.1250" recessed
Water hole plug.................................................. 1 " NPTF thread
Assemble 2.000" to 2.250" below machined
surface
Core hole plug............................................................. 1 3/4 "-16
150-180 lb-ft (204-244 Nm) torque
Oil drain plug (Nylon washer) ............................................ 18mm
25-35 lb-ft (34*37 Nm) torque
*Apply sealing compound to plugs used without gaskets or teflon.
After installation, a 1.2187 " diameter rod inserted in oil line must pass inner face of plug.
STUD TORQUE SPECIFICATIONS
APPLICATION
TORQUE
TORQUE
HEIGHT
(Ib-ft)
(Nm)
(+.0312 ")
Exhaust manifold stud ......................................................................... 25-40
34-54
--
Injector clamp stud .............................................................................. 10-25
14-34
--
Water manifold stud ............................................................................ 10-25
14-34
--
SPRING SPECIFICATIONS
SPRING
REPLACE WHEN LOAD
IS LESS THAN:
Cam follower (11 coils - .177 " wire) .................................................................................
172 lbs. @ 2.1250"
Cam follower (11 1/2 coils - .162 "wire) ............................................................................
133 lbs. @ 2.1094"
Exhaust valve (two-valve cylinder head) ..........................................................................
25 lbs. @ 2.2000"
10-2-141
