INJECTION PUMP MEASURING DEVICE
(8) Measure excess fuel injection quantity as follows:
(a) Set lower control lever assembly (17) in maximum speed position.
(b) Operate pump at low speed specified in calibration data. Measure quantity of excess fuel. If quantity
is within limits, go to step (10). If quantity is not within limits, remove flange nut (14), intermediate
disc (22), and lower control lever assembly (17).
(c) Do steps (11), (22), and (23) of a. Disassembly and steps (46) to (48), and (59) of c. Assembly to
replace flyweight holder assembly plug.
(d) Install lower control lever assembly (17), intermediate disc (22), and flange nut (14).
(e) Repeat steps (a) and (b).