(2) Adjust full-load injection as follows:
(a) Set control lever (2) in maximum speed
position and check that governor
operates at speed specified in
limits, go to step (d). If speed is not
within limits, do steps (1) to (4), (11).
(17), (22) to (26), (29, (30), and (32) of
a. Disassembly to remove governor
(b) Do steps (27), (31), (35), (37) to (40),
(47), (48), (54), (59), (65), and (66)
of c. Assembly to install governor
(c) Repeat step (a).
Ensure to tighten nut (3) before each
(d) Measure injection quantity at speed
specified in calibration data. If quantity
is within limits, go to step (3). If
quantity is not within limits, loosen nut
(3) and adjust full-load adjusting screw
(4). Tighten nut (3) 52 to 78 lb-in (6 - 9
N·m) and measure injection quantity
again to ensure correct quantity.
(3) Adjust supply pressure as follows:
(a) Measure pump chamber pressure at
pressure is within limits go to step (4).
If pressure is below limits, install
adjusting device and push in plug (5) in
control valve (6). Remove adjusting
(b) If measurement is above limits, remove
control valve (6) and perform all