DISASSEMBLE BRAKE SHOE AND LINER ASSEMBLY
The complete disassembly of the brakes is not
necessary for the removal of the hub spindle. Adequate
working clearance is provided by only removing the
brake shoe return spring.
ASSEMBLE HUB AND DRUM ASSEMBLY
PREPARE FOR ASSEMBLY
All parts should be cleaned, inspected and repaired
where necessary before reassembly. Refer to the
Cleaning, Inspection and Repair instructions on page 5-
INSTALL BRAKE ASSEMBLIES
If the brakes were removed during the wheel end
disassembly follow the procedures below:
a. Install brake cylinder and push rods.
b. Install brake shoe and liner assemblies over
c. Install anchor pin plate, nut and cotter key.
d. Align push rods with shoe webs and hook brake
shoe return spring.
e. For further detailed information, consult the "H"
c. Install the wheel bearing adjusting nut.
Series Brakes section on page 3-1.
If hub bearings cups have been removed for
replacement, install new cups with a suitable driving
a. Lift the hub and drum assembly onto the hub
spindle and position so that the inner cup rests on the
inner bearing rolls.
b. Install the floating ring gear assembly, while at
the same time lifting the weight of the hub and drum
assembly to allow the outer bearing to mate with outer
hub bearing cup.