VARIABLE DISPLACEMENT PUMP
Certain tools are required that are not normally carried
which are as follows:
1. Waldes Truarc #7 Retaining Ring Pliers
2. Drag Link Socket
3. 12 Point, 3/16 Socket
5. Tapered Bearing Puller
Ref. Snap on Part Numbers
Puller Bar CG350
Remove the shaft seal as outlined under Minor repair
procedures. The shaft seal must be removed before the
end cap screws are loosened to prevent the seal being
The end cap screws should not be loosened until
the shaft seal has been removed.
Remove charge pump and control valve as outlined
under Minor repair procedures.
Remove all but two (2) of the hex. cap screws holding
the end cap to the housing. Make sure the two
remaining screws are opposing each other.
There is an internal spring loading on the end cap and
as the last two (2) screws are loosened, it should begin
to separate from the housing. Loosen these screws
alternately until the end cap has fully separated from the
housing, then remove the screws entirely.