TM 5-3895-342-12
c. Cleaning and Inspection.
(2) Inspect the cap for damage. Replace a
(1) Clean all parts with a cleaning solvent.
damaged filler cap.
(2) Inspect the filter and all lines and fittings for
c. Installation. Install the oil filler cap on the
cracks, bends, or breaks. Replace
defective parts.
filler tube.
d. Installation. Reassemble oil filter using new
4-36. Oil Filler Tube Strainer
element and gasket. Install the oil filter, lines, and
a. Removal. Remove the oil filler tube strainer
4-35. Oil Filler Cap
a. Removal. Remove the oil filler cap (fig. 4-
30) from the filler tube.
Figure 4-31. Oil filler tube strainer removal.
b. Cleaning and Inspection.
(1) Clean all parts with a cleaning solvent.
Figure 4-30. Oil filler cap.
(2) Inspect all parts for defects and damage.
b. Cleaning and Inspection.
Replace defective or damaged parts.
(1) Clean the oil filler cap with a cleaning
c. Installation. Install the oil filler tube strainer
solvent.
Section XII. ENGINE CONTROL, METERS, AND GAGES
4-37. General
The engine controls. meters, and gages consist of a
choke control. governor control. ignition switch,
starter switch, fuel level gage, oil pressure gage.
controls. meters. and gages are located in the
engine housing front panel.
4-38. Choke Control
a.
Removal.
Remove the choke control as
ME 3895-342-12/4-32 C1
Figure 4-32. Choke control removal.
Change 1
4-19