15 DECEMBER 83
(Supersedes LO 5-3895-372-12, 5 OCTOBER 1979)
CONCRETE-MOBILE MIXER BODY M919 MODEL 8CM-24F
Reference: TM 5-3895-372-10, and -20, LO 9-2320-273-12 and FEDERAL SUPPLY
Hard time intervals and the related manhour times are
Clean parts or fittings with dry cleaning solvent (SD),
based on normal operation.
The man-hour time
Type II or equivalent. Dry before lubricating. Dotted
specified is the time you need to do all the services
arrow shafts indicate lubrication on both sides of
prescribed for a particular interval.
equipment. A dotted circle indicates a drain below.
Change the hard time interval if your lubricants are
Relubricate all items found contaminated after fording or
contaminated or if you are operating the equipment
longerthan-usual operating hours. The hard time interval
The lowest level of maintenance authorized to lubricate a
may be extended during periods of low activity. If
point is indicated by one of the following symbols as
extended, adequate preservation precautions must be
appropriate: Operator/Crew (C); and Organizational
Reporting errors and recommending improvements.
You can help improve this manual. If you find any
mistakes, or if you know of a way to improve the
Dry cleaning fluid is flammable. Do not use near a flame
procedures, please let us know. Mail your letter or DA
or excessive heat. Use only with adequate ventilation.
Form 2028 (Recommended Changes to Publications and
Avoid prolonged breathing of vapors and minimize skin
Blank Forms) direct to: Commander, US Army Tank-
Automotive Command, ATTN: DRSTA-MB, Warren, MI
48090. A reply will be furnished to you.
*The time specified is the time required to perform all services
at the particular interval.
CARD 1 OF 7